Participative Versus Assigned Production Standard Setting in a Repetitive Industrial Task: A Strategy for Improving Worker Productivity

Abstract

The participative standard with feedback condition was superior to the assigned difficult (140% of normal) standard with feedback condition in terms of worker productivity. The percentage increase in worker productivity with the participative standard and feedback condition was 46%, whereas the increase in the assigned difficult standard with feedback was 23%, compared to the control group (no standard, no feedback). Worker productivity also Improved significantly as a result of assigning a normal (100%) production standard with feedback, compared to the control group, and the increase was 12%. The participative standard with feedback condition emerges as the optimum strategy for improving worker productivity in a repetitive industrial production task.     

Isometric Pull and Push Strengths of Paraplegics in the Workspace: 2. Statistical Analysis of Spatial Factors

The effect of reach levels, horizontal angles, and vertical angles on isometric pull and push strengths of male and female was determined. Highly significant increases in men’s push strength were found between extreme to maximum reaches, and from extreme to normal reaches. However, for women’s push strength, a significant increase was found only between extreme to maximum reach. Significant or highly significant increases were found in men’s and women’s pull strength between the horizontal angle (θ) sagittal through the active shoulder (90°) and other angles (0, 45, and 135°). However, for men’s push strength, highly significant increases were found between the horizontal angle 45° from the frontal plane, and other angles. For women’s push strength, significant or highly significant increases were found between the horizontal angles 0° and angles of 90 and 135°. For men’s and women’s pull strength, significant or highly significant increases were found between the vertical angle (?), 90°, and other angles (–20, 0, and 45°). Similar increases were found for women’s push strength between the 45° angle and other angles. In the design of a workstation for paraplegics that requires pull and push forces, consideration must be given to the spatial factors.     

A combined frequency–severity approach for the analysis of rear-end crashes on urban arterials

Analysis of both the crash count and the severity of injury are required to provide the complete picture of the safety situation of any given roadway. The randomness of crashes, the one-way dependency of injury on crash occurrence and the difference in response types have typically led researchers into developing independent statistical models for crash count and severity classification. The Genetic Programming (GP) methodology adopts the concepts of evolutionary biology such as crossover and mutation in effectively giving a common heuristic approach to model the development for the two different modeling objectives. The chosen GP models have the highest hit rate for rear-end crash classification problem and the least error for function fitting (regression) problems. Higher Average Daily Traffic (ADT) is more likely to result in more crashes. Absence of on-street parking may result in diminished severity of injuries resulting from crashes as they may provide “soft” crash barrier in contrast to fixed road side objects. Graphical presentation of the frequency of crashes with varying input variables shed new light on the results and its interpretation. Higher friction coefficient of roadways result in reduced frequency of crashes during the morning peak hours, with the trend being reversed during the afternoon peak hours. Crash counts have been observed to be at a maximum at a surface width of 30 ft. Sensitivity analysis results reflect that ADT is responsible for the largest variation in crash counts on urban arterials.     

Acute and reproductive toxicity of nano-sized metal oxides (ZnO and TiO₂) to earthworms (Eisenia fetida)

An increase in nanomaterial applications will likely lead to an increased probability of environmental exposures, raising concerns regarding the safety of these materials. Recent studies have indicated that manufactured nanomaterials, such as metal oxides, have the potential to be harmful to aquatic and terrestrial organisms. The majority of nano-metal oxide research addressing potential toxicological issues has been focused in aquatic environments with very little terrestrial data. This study characterized the acute and reproductive toxicity of zinc oxide (ZnO) and titanium dioxide (TiO(2)) to earthworms (Eisenia fetida) in a terrestrial system. Following a 14 d exposure, nano-sized ZnO on filter paper was acutely toxic to E. fetida, while nano-sized TiO(2) did not exhibit acute toxicity. In contrast, neither nano-sized ZnO nor TiO(2) exhibited acute toxicity to earthworms in sand. Both nano-sized ZnO and TiO(2), following a 4 week exposure, caused reproductive effects in earthworms in artificial soil. Overall, nano-sized ZnO exhibited greater toxicity than nano-sized TiO(2) in Eisenia fetida.     

Mercury emissions and partitioning from Indian coal-fired power plants

In India coal combustion is the single largest source of emission of mercury which is a wide-spread persistent global toxicant, travelling across international borders through air and water. As a party to the Minamata convention, India aims to monitor and reduce Hg emissions and stricter norms are introduced for mercury emissions from power plants (30 μg/Nm³for flue gas in stack).This paper presents the results obtained during the experimental studies performed on mercury emissions at four coal-fired and one lignite-fired power plants in India. The mercury concentration in the feed coal varied between 0.12–0.27 mg/Kg. In the mercury mass balance, significant proportion of feed coal mercury has been found to be associated with fly ash, whereas bottom ash contained very low mercury. 80%–90% of mercury was released to air through stack gas. However, for circulating fluidised bed boiler burning lignite, about 64.8% of feed mercury was found to get captured in the fly ash and only 32.4% was released to air. The mercury emission factor was found to lie in the range of 4.7–15.7 mg/GJ.     

Metal-oxide coated Graphene oxide nano-composite for the treatment of pharmaceutical compound in photocatalytic reactor: Batch,Kinetics and Mathematical Modeling using Response Surface Methodology and Artificial Neural Network

Environmental Science and Pollution Research - Titanium dioxide (TiO2) photocatalyst has gained constant interest in the treatment of wastewater because of its greater stability, lower cost,...     

Spatial elements of mortality risk in old-growth forests

For many species of long-lived organisms, such as trees, survival appears to be the most critical vital rate affecting population persistence. However, methods commonly used to quantify tree death, such as relating tree mortality risk solely to diameter growth, almost certainly do not account for important spatial processes. Our goal in this study was to detect and, if present, to quantify the relevance of such processes. For this purpose, we examined purely spatial aspects of mortality for four species, Abies concolor, Abies magnifica, Calocedrus decurrens, and Pinus lambertiana, in an old-growth conifer forest in the Sierra Nevada of California, USA. The analysis was performed using data from nine fully mapped long-term monitoring plots. In three cases, the results unequivocally supported the inclusion of spatial information in models used to predict mortality. For Abies concolor, our results suggested that growth rate may not always adequately capture increased mortality risk due to competition. We also found evidence of a facilitative effect for this species, with mortality risk decreasing with proximity to conspecific neighbors. For Pinus lambertiana, mortality risk increased with density of conspecific neighbors, in keeping with a mechanism of increased pathogen or insect pressure (i.e., a Janzen-Connell type effect). Finally, we found that models estimating risk of being crushed were strongly improved by the inclusion of a simple index of spatial proximity. Not only did spatial indices improve models, those improvements were relevant for mortality prediction. For P. lambertiana, spatial factors were important for estimation of mortality risk regardless of growth rate. For A. concolor, although most of the population fell within spatial conditions in which mortality risk was well described by growth, trees that died occurred outside those conditions in a disproportionate fashion. Furthermore, as stands of A. concolor become increasingly dense, such spatial factors are likely to become increasingly important. In general, models that fail to account for spatial pattern are at risk of failure as conditions change.     

Role of competition in phytoplankton population for the occurrence and control of plankton bloom in the presence of environmental fluctuations

Termination of harmful algal blooms (HABs) and coexistence of phytoplankton–zooplankton populations are of great importance to human health, ecosystem, environment, tourism and fisheries. In this paper, we propose a three component model consisting of non-toxic phytoplankton (NTP), toxin producing phytoplankton (TPP) and zooplankton (Z). The growth of zooplankton species is assume to reduce due to toxic chemicals released by TPP population. We have extended the model proposed by Chattopadhyay et al. [Chattopadhyay, J., Sarkar, R.R., Pal, S., 2004. Mathematical modelling of harmful algal blooms supported by experimental findings. Ecol. Comp. 1, 225–235] by including competition terms between TPP and NTP. We observe the effect of competition factors both in the presence and absence of the environmental fluctuation. From our field as well as model analysis we observe that competition helps in the coexistence of the species, but if the effect of competition is very high on the TPP population, it results in planktonic bloom. It is shown that the coexistence equilibrium loses its stability when the competition coefficient crosses a critical value and resulting Hopf-bifurcation around the positive equilibrium depicting oscillations phenomena of the populations.     

Concept of optimum basin thickness in heat exchanger–assisted solar stills

Environmental Science and Pollution Research - It is suggested by many works on solar stills that water thickness should be kept as low as possible to reduce its thermal inertia and obtain best...     

Re-examining the environmental Kuznets curve (EKC) for India via the multiple threshold NARDL procedure

Environmental Science and Pollution Research - Irrespective of the vast array of empirical evaluations pertaining to the environmental Kuznets curve (EKC) hypothesis, both for India and other...